User Manual

Using the Scan Tool
VIEWING OEM ENHANCED DTCs
40 3040e
3. If more than one code was retrieved press the DTC/FF button, as
necessary, to display additional codes one at a time.
4. When the last retrieved DTC has been displayed and the DTC/FF
button is pressed, the Scan Tool returns to the “Priority” code.
 To view additional enhanced DTCs, repeat steps 1 through 4,
above.
 To exit the enhanced mode, press the SYSTEM MENU
button to return to the System Menu. Use the UP
and
DOWN
buttons, as necessary, to highlight Global OBD, then
press the ENTER
button to return to the Global OBD2 mode.
Ford/Mazda Enhanced DTCs
Mazda Enhanced DTCs are available for Mazda-branded
Ford vehicles only.
When Ford OEM Enhanced is chosen from
the System Menu, the Ford Enhanced
menu displays. You may view DTCs for
either the “Continuous Memory Test”,
“KOEO (Key On Engine Off) Test” or
“KOER (Key On Engine Running) Test.”
1. Use the UP
and DOWN buttons,
as necessary, to highlight the desired
option, then press the ENTER
button.
 If KOER is selected, an advisory
message shows on the Scan Tool’s
display.
- Start and warm the engine to
normal operating temperature,
then press the ENTER
button.
Proceed to step 3.
2. If KOEO or Continuous Memory is
selected, an “instructional” message
shows on the Scan Tool’s display.
 Turn the ignition OFF, then back
ON. Press the ENTER
button.
Proceed to step 3.
3. A “One moment please” message
displays while the test is in progress.
 If the Scan Tool fails to link to the
vehicle’s computer, a “Communication
Error” message shows on the Scan
Tool’s display.