User Manual

Using the Scan Tool
VIEWING OEM ENHANCED DTCs
42 3040e
 A visible icon indicates that the Scan Tool is being powered
through the vehicle’s DLC connector.
 A visible icon indicates that the
Scan Tool is linked to (communica-
ting with) the vehicle’s computer.
 The upper left corner of the display
shows the Diagnostic Trouble Code
(DTC), the number of the code
currently being displayed and the
total number of codes retrieved, and
the type of code.
 The related code definition is shown in the lower section of the
LCD display.
If the definition for the
currently displayed code is
not available, an advisory
message shows on the
diagnostic tool’s LCD
display.
I/M MONITOR STATUS
icons are not displayed
when viewing enhanced
DTCs.
In the case of long code definitions, a small arrow is
shown in the upper/lower right-hand corner of the code
display area to indicate the presence of additional
information. Use the UP
and DOWN buttons,
as necessary, to view the additional information.
 For additional help with a displayed DTC, use the UP and
DOWN
buttons, as necessary, to highlight Help, then press
the ENTER
button.
 The Scan Tool will display a code only
if codes are present in the vehicle’s
computer memory. If no codes are
present, a “System Pass” message is
displayed. Press any Hotkey.
6. If more than one code was retrieved
press the DTC/FF button, as necessary,
to display additional codes one at a time.
7. When the last retrieved DTC has been displayed and the DTC/FF
button is pressed, the Scan Tool returns to the “Priority” code.
 To view additional enhanced DTCs, repeat steps 1 through 6,
above.
 To exit the enhanced mode, press the SYSTEM MENU
button to return to the System Menu. Use the UP
and
DOWN
buttons, as necessary, to highlight Global OBD, then
press the ENTER
button to return to the Global OBD2 mode.