User Manual

Using the Scan Tool
VIEWING OEM ENHANCED DTCs
46 3040e
In the case of long code definitions, a small arrow is
shown in the upper/lower right-hand corner of the code
display area to indicate the presence of additional
information. Use the UP
and DOWN buttons,
as necessary, to view the additional information.
 The Scan Tool will display a code
only if codes are present in the
vehicle’s computer memory. If no
codes are present, a “No OEM
Enhanced DTC’s are presently stored
in the vehicle’s computer” is displayed.
Press the SYSTEM MENU
button to return to the System Menu.
3. If more than one code was retrieved press the DTC/FF button, as
necessary, to display additional codes one at a time.
4. When the last retrieved DTC has been displayed and the DTC.FF
button is pressed, the diagnostic tool returns to the “Priority” code.
 To view additional enhanced DTCs, repeat steps 1 through 4,
above.
 To exit the enhanced mode, press the SYSTEM MENU
button to return to the System Menu. Use the UP
and
DOWN
buttons, as necessary, to highlight Global OBD, then
press the ENTER
button to return to the Global OBD2 mode.
Toyota/Lexus Enhanced DTCs
When Toyota OEM Enhanced is chosen
from the Main Menu, the Scan Tool
retrieves OEM enhanced DTCs from the
vehicle’s computer.
1. A “One moment please” message
displays, while the Scan Tool retrieves
the selected DTCs.
 If the Scan Tool fails to link to the
vehicle’s computer, a “Communica-
tion Error” message shows on the
Scan Tool’s display.
- Ensure your vehicle is OBD2
compliant. See VEHICLES
COVERED on page 4 for vehicle
compliance verification information.
- Verify the connection at the DLC, and verify the ignition is ON.
- Turn the ignition OFF, wait 5 seconds, then back ON to reset
the computer.
- Press the LINK
button to continue.