User Manual

Using the Scan Tool
VIEWING ABS DTCs
48 3040e
3. If more than one code was retrieved press the DTC/FF button, as
necessary, to display additional codes one at a time.
4. When the last retrieved DTC has been displayed and the DTC/FF
button is pressed, the Scan Tool returns to the “Priority” code.
 To view additional enhanced DTCs, repeat steps 1 through 4,
above.
 To exit the enhanced mode, press the SYSTEM MENU
button to return to the System Menu. Use the UP
and
DOWN
buttons, as necessary, to highlight Global OBD, then
press the ENTER
button to return to the Global OBD2 mode.
VIEWING ABS DTCs
Refer to Vehicle Applications - ABS on page 82 for vehicle
makes covered. For a complete list of vehicle’s covered,
please visit www.innova.com.
Reading ABS DTCs
1. When ABS is chosen from the System
Menu, a "One moment please"
message displays while the Scan Tool
retrieves the selected DTCs.
 If the vehicle does not support ABS
communication, an advisory message
shows on the Scan Tool’s display.
Press the SYSTEM MENU
button to return to the System Menu.
 If the Scan Tool fails to link to the
vehicle’s computer, a “Linking Failed”
message shows on the Scan Tool’s
display.
- Verify the connection at the DLC,
and verify the ignition is ON.
- Turn the ignition OFF, wait 5
seconds, then turn back ON to
reset the computer.
- Press the LINK
button to
continue.
 If the Scan Tool cannot link to the
vehicle’s computer after three
attempts, the message “Contact
Technical Support” displays.
- Press the SYSTEM MENU
button to return to the System
Menu.
- Turn the ignition off, and disconnect the Scan Tool.