User Manual

Live Data Mode
RECORDING (CAPTURING) LIVE DATA
25
 If Live Data is not supported by the vehicle under test, an
advis
ory message displays. Press SYSTEM MENU
to return
to the System Menu.
 If custom Live Data was previously configured, the Select PIDs
to Use screen d
isplays
.
-
To use the existing custom Live data selections, select Use
existing PIDs, then press ENTER . Proceed to step 5.
- To configure new custom Live Data, select Select new PIDs,
then press ENTER
. The Custom Live Data menu displays.
Proceed to step 3.
 If custom Live Data was not previously selected, the Custom
Live Data menu displays. Proceed to step 3.
3. Press UP
and DOWN to scroll
through the available PIDs. When a PID
you wish to display is highlighted, press
ENTER
(a "checkmark" shows to
confirm your selection). Repeat until
only the PIDs you want to display have
all been selected.
 To deselect a PID, highlight the PID, then press ENTER .
The checkmark is removed.
4. Wh
en you are finished making your selection(s), press LD to continue.
 If no PIDs have been selected, an advisory message displays.
Press EN
TER
to return to the Custom Live Data menu.
5. The Scan To
ol is now in "Custo
m Live Data" mode. Only the PIDs
you selected are shown.
 To change the current custom Live
Data selections, select Rese
lect
PI
Ds, then press ENTER
to
return to the Custom Live
Data
menu. Repeat step 3.
6. T
o exit the "Custom Live Data" mode
,
press
LD to return to the Live Data Menu
.
RECORDING (CAPTURING) LIVE DATA
You can record and save several frames of Live Data information for
each PID supported by the vehicle in the Scan Tool's memory.
There are two ways that the Scan Tool can record Live Data:
 Record by DTC Trigger
 Record by Manual Trigger
If LINK
is pressed at any time while in Live Data mode,
any recorded Live Data will be erased from the Scan Tool’s
memory.