User Manual

Live Data Mode
LIVE DATA PLAYBACK
29
When you select Yes from the Record Live Data confirmation
screen, the Scan Tool enters the "Live Data Playback" mode,
and the Playback Live Data menu displays.
3. Select Continuous Playback or Frame
by Frame, as desired, then press ENTER
.
 The display shows the recorded
Li
ve Data, beginning with the
"trigger" frame.
 Only a limited amount of PID data
can be displayed on the scre
en at
one time. If addition
al PID data is available, a small arrow
is
shown on the display. Pres
s UP
and DOWN , as
necessary, to view all avai
lable PID data.
 When viewing recorded Live Data, look for any irregularities in any
of
the PID values/signal information (LTFT %, RPM, MAP, TEMP
,
etc.). If a
ny PIDs are not within specification, or irregularities ar
e
det
ected, follow the procedures in the vehicle's service repair
manual to perform additional troubleshooting and repair.
4. When you select Continuous
Playback, the Scan Tool plays
recorded data at a rate of one frame
/
15 seconds. W
hen playback is finished,
a Playback Complete message displays
.
 To play the data back again, select
Co
ntinuous Playback or
Frame by
Frame, as desired, then press
EN
TER
.
 To exit Live Data Playback mode and return to Live Data mode,
select Exit Play
back, then press ENTER
.
5. When Fram
e by Frame is selected, you must scroll the individua
l
frames manually.
 When you have viewed all PID information for the current frame of
Live Data
, select Next Frame or Previous Frame, as desire
d,
then
press ENTER
.
 To exit Live Data Playback mode, select Exit Playback, then
press EN
TER
.
If
there is no Live Data currently stored in the Scan Tool's
memory, an advisory message shows on the display. Press LD
to exit the "Live Data Playback" mode.