User Manual

7
- Thereafter calibrate twice a year or every 10,000 miles, whichever comes
first
Race car
- Calibrate before first installation of new sensor
- Calibrate once per race weekend
Dyno use
- Calibrate new sensor
- Calibrate every 2-3 days, depending on usage
5 Software (LogWorks 3 and LM Programmer)
5.1 Download the Logworks 3 software package
1. Open your web browser and go to:
http://www.innovatemotorsports.com/support.php
2. The LogWorks 3 software download will be the very first thing on the
page, click the link to download the software.
5.2 Installing software
1. Double click on the Logworks 3 installer previously downloaded.
2. The installer will start, follow the prompts to install the software.
3. Once the software has been installed the LogWorks software, LM
Programmer and LC-2 manual can then be located by navigating
through Start->Programs->LogWorks3.
5.3 Connecting to LM Programmer
LM Programmer is used to update firmware, change fuel types, change
sensor type, and program the two analog outputs.
1. Connect the OUT port of the LC-2 to the provided serial
programming cable. Connect the other end of the serial
programming cable to your computer. If your computer does not
have a serial port, you can purchase a USB to Serial adapter from
Innovate Motorsports (P/N 3733) or use any USB to serial adaptor
that includes drivers. Make sure that nothing is connected to the IN
port of the LC-2
2. Power up the LC-2.
3. Launch LM Programmer. The LM Programmer application can be
launched from Start->Programs->LogWorks3->LM Programmer from
the Windows task bar.
5.3.1 Analog Outputs
1. Connect the LC-2 to the computer and launch LM Programmer.