Quick Start Guide Manual

LM-2 Accessories:
 LM-2 to MTS patch cable, 4 pin micro fit to 2.5mm male stereo
P/N: 3812
 XD-16 (Air/Fuel Digital Gauge) P/N3780
 Exhaust Clamp: #3728
 Stainless Steel Bung w/ Steel Plug #3736
 HBX-1: Heat-sinking Bung Extender: #3729
 Double Length Bung: P/N 3764
 LM-2 Window Mount: P/N 3814
Replacement Parts:
 Power Cable: P/N 3808
 OBD-II Cable: P/N 3809
 Bung/Plug set: P/N 3735
 Sensor (Bosch LSU4.2): P/N 3737
 8ft Sensor Cable: P/N 3810
 Analog Cable: P/N 3811
 USB Cable: P/N 3813
Order parts, get support, find FAQ answers, and read case
studies at www.tuneyourengine.com
Warning!
1) The Oxygen Sensor used with this device gets very hot in
operation. Do not touch the hot sensor. Do not let a hot sensor
touch a combustible surface. Do not use the sensor with or near
flammable liquids or gases. Failure to heed these warnings may
result in severe burns, explosions or fires. 2) When installed in
the exhaust, the oxygen sensor MUST be connected and
operating with the LM-2 whenever the car is running. An un-
powered oxygen sensor will be quickly damaged when exposed
to hot exhaust gases.
< (10-2303.B)
LM-2
QUICK START GUIDE
The complete instruction manual is on the CD
Warning!
1) The Oxygen Sensor used with this device gets very hot in operation. Do not touch
the hot sensor or let a hot sensor touch a combustible surface. 2) When installed in
the exhaust, the oxygen sensor MUST be connected and operating with the LM-2
whenever the car is running. An un-powered oxygen sensor will be quickly damaged.