Quick Start Guide Manual

Selecting Channels to Display

1. Launch LogWorks from your iPhone or iPod touch.

2. Press the LogWorks tab.

3. On the upper left-hand corner you will see a

icon, press it

to enter the configuration screen.

4. The configuration screen has three parameters to configure:

Imperial Units: Allows you

to select Imperial Units or

Metric

Lambda or AFR: If there

is any Innovate

Motorsports A/F meter

connected to the OT-2

you can chose to display

the channels as AFR or

Lambda.

Gauges: Chose which

channel to display on the

gauge. Note: Channels

available for display must

be enabled from the OT-2

tab first.

5. Press Done on the upper right hand corner when done

configuring.

< (10-2303.B)

OT-2

QUICK START GUIDE

The complete instruction manual is on the CD

Order parts, get support, find FAQ answers, and read case

studies at www.tuneyourengine.com

11-0126

PAGE 1
Selecting Channels to Display 1. Launch LogWorks from your iPhone or iPod touch. < (10-2303.B) 2. Press the LogWorks tab. OT-2 3. On the upper left-hand corner you will see a to enter the configuration screen. icon, press it QUICK START GUIDE The complete instruction manual is on the CD 4.
PAGE 2
The complete instruction manual is on the CD OT-2 QUICK START GUIDE iPhone and iPod touch network configuration 1. Install the LogWorks application from the Apple App Store. A search for “LogWorks” will yield results for the application. Once installed you should see the LogWorks icon. 2. Connect the OT-2 to your vehicle’s OBD-II port. At minimum you should see the OT-2’s Power light come on and stay steady. 3. In your iPhone or iPod touch go to Settings then Wi-Fi. Make sure that Wi-Fi is set to ON. 4.