UH F MULTI CHANNELS WIRELESS MICROPHONE SYSTEM USER'S MANUAL PLEASE READ THIS MANUAL CAREFULLY BEFORE OPERATION
INTRODUCTION Thank you for choosing our UH F multi channels wireless microphone system. Your new system is rugged, reliable, easy to set up and operate, and produces outstanding audio clarity. Whether you're a vocalist, guitarist or instrumentalist, this wireless system will show you how easy wireless can be, and how good wireless can sound. This user guide included with your system will tell you all you need to know to get your system working right away. FEATURES 1.
RECEIVER PARTS DESCRIPTION Single Channel 1 3 4 5 2 7 8 3 4 5 7 8 6 Front 9 10 11 12 Rear Dual Channels 81 2 7 3 4 5 6 Front 9 10 11 12 9 Rear 1. On/Off switch: Turn on/off the receiver. 2. Infrared (IR) port: Broadcasts IR signal to transmitter to synchronize frequencies. 3. Menu switch: Press to scroll through menu options. 4. Select switch: Press to select the currently displayed menu option. 5. Sync Button: Press to initiate IR connection between receiver and transmitter. 6.
HANDHELD MICROPHONE PARTS DESCRIPTION UHF-6000HHM FCC ID:2AE6GUHF-6000HHM 1. Interchangeable microphone head 2. Power / Infrared(IR) /Mute indicator: Green-ready; Orange-mute on; Flashing orange-IR transmission in process 3. LCD screen: display group, channel number and battery power. 4. On-off / mute switch: Press and hold 1~2 seconds to turn microphone on or off. Press shortly to mute or unmute. 5. Select switch: To set up transmitter channel manually. 6. Battery cover/compartment 7.
RECEIVER PROGRAMMING SYSTEM SETUP Note: Transmitting devices such as cellular phones and two-way radios may interfere with wireless audio transmissions. Keep your transmitters and receivers away from these and other potential sources of interference. 1. Turn on receiver. LCD will light. 2. Channel A set up Group Selection 1. Press CH-A “MENU” button to move cursor to “GROUP SELECT”. 2. Press CH-A “SELECT” button to increase the group number by one. 3.
MANUAL SETUP OF TRANSMITTER FREQUENCY You can set up transmitter frequency manually also. 1. Press and hold the “SELECT” button until GROUP and CHANNEL displays begin to alternate. 2. To change the group setting, release the “SELECT” button while GROUP is displayed. While GROUP is flashing, press “SELECT” button to increase the group number by one. 3. To change the channel setting, release the “SELECT” button while CHANNEL is displayed.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
