User's Guide

FCC Statement
1. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received, including interference that may cause undesired operation.
2. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate
the equipment.
NOTE:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
SAR Information Statement
Your wireless phone is a radio transmitter and receiver. It is designed and manufactured not to exceed the emission limits for exposure
to radiofrequency (RF) energy set by the Federal Communications Commission of the U.S. Government. These limits are part of
comprehensive guidelines and establish permitted levels of RF energy for the general population. The guidelines are based on
standards that were developed by independent scientific organizations through periodic and thorough evaluation of scientific studies.
The standards include a substantial safety margin designed to assure the safety of all persons, regardless of age and health. The
exposure standard for wireless mobile phones employs a unit of measurement known as the Specific Absorption Rate, or SAR. The
SAR limits set by the FCC are 1.6 W/kg for Head and 4.0 W/kg for Extremity. * Tests for SAR are conducted with the smart watch
phone transmitting at its highest certified power level in all tested frequency bands. Although the SAR is determined at the highest
certified power level, the actual SAR level of the smart watch while operating can be well below the maximum value. This is because
the smart watch phone is designed to operate at multiple power levels so as to use only the power required to reach the network. In
general, the closer you are to a wireless base station antenna, the lower the power output. Before a smart watch phone model is
available for sale to the public, it must be tested and certified to the FCC that it does not exceed the limit established by the government
adopted requirement for safe exposure. The tests are performed in positions and locations (e.g., at the ear and worn on the body) as
required by the FCC for each model. The highest SAR value for this model smart watch phone when tested for use at next to mouth is
1.184 W/Kg and when worn on wrist, as described in this user guide, is 1.683 W/Kg(wrist-worn mode measurements differ among
phone models, depending upon available accessories and FCC requirements). While there may be differences between the SAR levels
of various phones and at various positions, they all meet the government requirement for safe exposure. The FCC has granted an
Equipment Authorization for this model smart watch phone with all reported SAR levels evaluated as in compliance with the FCC
RFexposure guidelines. SAR information on this model smart watch phone is on file with the FCC and can be found under the Display
Grant section of http://www.fcc.gov/ oet/fccid after searching on
FCC ID: 2AUBCSW28 Additional information on Specific Absorption Rates (SAR) can be found on the Cellular Telecommunications
Industry Asso-ciation (CTIA) web-site at http://www.wow-com.com. * In the United States and Canada, the SAR limit for smart watch
phones used by the public are 1.6 watts/kg (W/kg) for head and averaged over one gram of tissue and 4.0 watts/kg (W/kg) for extremity
averaged over ten gram of tissue. The standard incorporates a sub-stantial margin of safety to give additional protection for the public
and to account for any variations in measurements.
Next to mouth and Wrist-worn mode Operation
This device was tested for typical next to mouth and wrist-worn operations. To comply with RF exposure requirements, for next to
mouth mode, a minimum separation distance of 10mm must be maintained between the user’s head and the handset, including the
antenna, for wrist-worn mode, a minimum separation distance of 0mm must be maintained between the user’s wrist and the handset,
including the antenna. Third-party belt-clips, holsters, and similar accessories used by this device should not contain any metallic
components. Accessories that do not meet these requirements may not comply with RF exposure requirements and should be avoided.
Use only the supplied or an approved antenna.