User Manual
Table Of Contents
- LC 1200 Manual (v1.00)
- FCC Statement of Conditions
- Warranty Statement
- How to use this manual
- Table of Contents
- Ch. 1 - The LC 1200 System
- Ch. 2 - The LC unit
- Ch. 3 - Tags & TAD
- Ch. 4 - The Magnetic Switch
- Ch. 5. - Passive Infrared Reader (PIR)
- Ch. 6 - The Keypad
- Ch. 7 - Push Button Override (PBO)
- Ch. 8 - External Sounders
- Ch. 9 - Magnetic Locks
- Ch. 10 - Elevator Deactivation
- Ch. 11 - Automatic Door Deactivation
- Ch. 12 - Fire Panel Interface (FPI)
- Ch. 13 - Timer
- Ch. 14. - Alert Panels
- Ch. 15 - System Maintenance & Testing
- Ch. 16 - FAQ & Troubleshooting
- Appendix A: Component Cut Sheets
- Glossary
- Index
13-2 Timer LC 1200 Manual
Wiring
You will need 22-gauge, 4-conductor plenum-
rated cable for this connection.
To wire the Timer to the LC unit, refer to Figure
13.2 and use the following instructions:
1. Using the BLACK wire, connect the “-“
pin of the Timer to P3-pin5 (Ground) of
the LC unit.
2. Using the RED wire, connect the “+”
pin of the Timer to P3-pin4 (+12V) of
the LC unit.
3. Using the WHITE wire, connect the
“N.O” pin of the Timer to P1-pin2
(Perimeter In) of the LC unit.
4. Using the GREEN wire, connect the
“C” pin of the Timer to P1-pin1
(Perimeter Out) of the LC unit.
Figure 13.2 Wiring the Timer