User Manual
Table Of Contents
- LC 1200 Manual (v1.00)
- FCC Statement of Conditions
- Warranty Statement
- How to use this manual
- Table of Contents
- Ch. 1 - The LC 1200 System
- Ch. 2 - The LC unit
- Ch. 3 - Tags & TAD
- Ch. 4 - The Magnetic Switch
- Ch. 5. - Passive Infrared Reader (PIR)
- Ch. 6 - The Keypad
- Ch. 7 - Push Button Override (PBO)
- Ch. 8 - External Sounders
- Ch. 9 - Magnetic Locks
- Ch. 10 - Elevator Deactivation
- Ch. 11 - Automatic Door Deactivation
- Ch. 12 - Fire Panel Interface (FPI)
- Ch. 13 - Timer
- Ch. 14. - Alert Panels
- Ch. 15 - System Maintenance & Testing
- Ch. 16 - FAQ & Troubleshooting
- Appendix A: Component Cut Sheets
- Glossary
- Index
16-2 FAQ & Troubleshooting LC 1200 Manual
System (General):
If you are locking the doors, what happens in the
case of a fire?
Accutech follows NFPA codes and regulations.
Therefore, in the event of a fire, all Accutech
restraints will be disabled (audial and visual
alarms remain active).
How can I reduce nuisance alarms?
Nuisance alarms are typically caused by:
improper zone coverage (see page 3-3
“Verifying proper zone coverage” and
page 2-8 “Adjusting the Tx Activation
Field”)
improper storage of Tags (see page 3-2)
How do I change the Keypad Escort time?
To change the Keypad Escort time, see page 6-9.
System (Maintenance):
How often should I test my zones?
Accutech recommends that performance testing
be done on a monthly basis. However, each
facility should review and modify the testing
procedures as necessary to meet their own
unique security requirements.
Who do I call about upgrading or adding to my
system?
If you would like information about upgrading
or adding to your system, contact your local area
Accutech Representative.
How do I order replacement
Tags/Bands/Components?
If you would like to order replacement
Tags/Band/Components for your system, contact
your local area Accutech Representative.