User Manual

LC 1200 Manual The LC unit 2-3
Mounting
To mount an LC unit, refer to Figure 2.5 and use
the following instructions:
1. Remove the LC unit cover and screws.
2. Locate, align, mark-out, and drill 4
mounting holes in the wall
corresponding to the mounting holes of
the LC unit.
3. Using appropriate hardware for the
mounting surface, install the four
anchors.
4. Install the upper screws leaving about a
1/8
th
of an inch exposed.
5. Make any wire accommodations (such
as fishing wires through the back cover
or planning conduit/panduit interface)
that are easier completed with the LC
unit unmounted.
6. When finished, install the last two
mounting screws then tighten all 4
mounting screws.
7. Note the Tamper Switch adjustment
section on page 2-7.
8. Proceed to wiring.
Wiring
The LC unit uses a 12V DC plug-in for power.
For instructions on wiring to the LC unit, refer
to the chapter of the component you are
interfacing with.
Note: P3 pins 1 and 2 come from the factory
with a jumper wire between them (see page 2-6).
Figure 2.5 The LC unit