User Manual

LC 1200 Manual Tags & TAD 3-1
Tags & TAD
 Overview
 Tag material
 Attaching Tags
 Tag and Band Maintenance
 LED Tag
 The TAD
Overview
The LC system uses LC 1200 System Tags
(Figure 3.1). The Tags have two styles –
 LT (Long Term) (
Part # 77L016)
 SB (Slotted Back) (
Part # 67L016)
The Tag band (
Part # 100901) is made of
nylon-mesh-reinforced vinyl (latex-free).
The band is designed to resist tearing caused
by pulling or chewing on the band.
However, if the band becomes frayed or torn
it will need to be replaced. In long-term
applications, the band should be replaced
periodically for cleanliness.
or
LT SB
Figure 3.1
LT and SB Tag styles (bands not shown)
Tag material
The Tag case is made of FDA-approved
Lexan® plastic and the Tag band is latex-
free.
Attaching LT/SB Tags
To attach an LT/SB Tag to the resident use
the following instructions:
1. With the snaps pointing in the same
direction as the Accutech logo, slide
the plastic band through the Slot.
(
Figure 3.2).
Figure 3.2 Attaching LT Tag style
2. Adjust the band length to the nearest
accommodating hole for a
comfortable fit around the resident’s
extremity.
NOTE: Once the band is secured, it
cannot be adjusted.
3. Put the male part of the Snap
through the selected hole.
4. Fold over the female part of the
Snap and secure to the male part by
squeezing until they snap together.
5. Using scissors, trim any excess band
material (Figure 3.3).
Figure 3.3 Securing the band