User Manual

6-2 The Keypad LC 1200 Manual
Positioning
The Keypad should be located within 3 to 5 feet
of the monitored door or elevator. In hallway
applications, mount the Keypad just outside of
the zone to avoid alarm activation when
escorting a monitored resident.
Figure 6.2 Surface Mounting the Keypad
Surface Mounting
The Keypad is designed to be surface mounted
using the white back box provided.
To surface mount the Keypad, refer to Figure
6.2 and use the following instructions:
1. Using a screwdriver, separate the
Keypad from the white back box by
removing the two screws.
2. If you are using wire molding, push or
cut out the two knock-outs located on
the top and bottom of the white back
box for the wiring molding to interface
with the white back box.
3. If you are running cable behind the wall,
put or drill out the center knock-out in
the white back box to wire from behind
the wall into the white back box.
4. Drill out the four mounting knock-outs
in the white back box.
5. Using the white back box as a template,
mark all the holes that need to be drilled.
6. Drill the necessary holes in the
mounting surface.
7. Secure the white back box to the
mounting surface with appropriate
hardware.
8. Replace the Keypad to the white back
box using the two screws.