User Manual

LC 1200 Manual The Keypad 6-9
light steadily for 2 seconds and will
return to slow flashing
5. Repeat steps 2-5 to delete another user
code or press
[#] to exit the
programming menu and return the
Keypad to normal operation.
Resetting the master code
NOTE: The following operation should only be
performed by authorized personnel.
If you forget the master code, you will need to
reset the Keypad to the factory default master
code of [1][2][3][4] and then assign a new
master code.
NOTE:
This operation is time-sensitive. Please read
through all the instructions before beginning.
To reset the master code, use the following
instructions:
1. Open the Keypad’s case, revealing the
printed circuit board.
2. Install the jumper across the two pins
labeled JP2.
3. Using a screwdriver or jumper wire,
momentarily short circuit the pins
labeled JP1.
4. Wait ten seconds, remove the jumper
from JP2, and immediately enter
[1][2][3][4][#]. The green LED will
light steadily for two seconds and then
start flashing slowly, indicating that the
programming menu is active.
NOTE: The master code is temporarily
reverted to default [1][2][3][4].
However, all other data programmed
previously remains intact.
5. Program a new master code immediately
(
see page 6.7) and record it in a secure
place.
Adjusting the Keypad Escort Time
To adjust the Keypad Escort Time, use the
following instructions:
1. Invoke the programming menu by
entering [*][*][master code][*][*].
When the programming menu is active,
the green LED flashes slowly,
approximately once every two seconds.
2. Enter
[2] to select the relay timer
function. The green LED will respond
by flashing rapidly, indicating that the
Keypad is ready to receive data.
3. Enter the escort time (two digits, from
01-98 seconds) and then press the
[#]
key. For example to set the escort time
for 15 seconds, enter
[1][5] followed
by [#].
The green LED will light steadily for 2
seconds and then will resume rapid
flashing.
4. Press
[#] to exit the programming menu
and return the Keypad to normal
operation.
5. To verify the new escort time, enter a
valid user code to initiate the Escort
function. The green LED will illuminate
for the duration of the Escort time.