User Manual

LC 1200 Manual Push Button Override (PBO) 7-1
Push Button Override
(PBO)
 Specifications
 Positioning
 Mounting
 Wiring to the Keypad
 Wiring to the LC unit
The Push Button Override (PBO) (Part # 700022;
Figure 7.1) triggers the Keypad’s Escort function;
this option overrides the presence of a Tag in the
zone to allow free access through the doorway
(no locks or alarms) from the non-Keypad side
of the door.
The PBO uses three LEDs:
 The Green LED indicates power.
 The Red LED indicates an alarm.
 The Yellow LED indicates the PBO has
been activated and the allotted escort
time is in progress. The time allotted to
pass through the doorway or zone is the
same as the Escort time on the Keypad.
Figure 7.1 Push Button Override (PBO)
Specifications
 Power Requirements
 Temperature
 Weight
Power Requirements
12V DC @ 55 mA
NOTE: The PBO triggers the Keypad; therefore,
the PBO current draw is based on the Keypad
used.
Temperature
The PBO operates best in an ambient
temperature between 35 and 90 degrees
Fahrenheit. Operation outside of this range may
cause unexpected or undesirable results,
including premature failure.
Weight
A PBO weighs approximately 4.3 ounces.
Positioning
The PBO should be positioned on the side of the
door opposite the Keypad. In other words, if the
Keypad is on the inside of the door, the PBO
should be on the outside of the door. The PBO
can be flush mounted or surface mounted using
the appropriate mounting box and hardware.