User Manual
Table Of Contents
- LC 1200 Manual (v1.00)
- FCC Statement of Conditions
- Warranty Statement
- How to use this manual
- Table of Contents
- Ch. 1 - The LC 1200 System
- Ch. 2 - The LC unit
- Ch. 3 - Tags & TAD
- Ch. 4 - The Magnetic Switch
- Ch. 5. - Passive Infrared Reader (PIR)
- Ch. 6 - The Keypad
- Ch. 7 - Push Button Override (PBO)
- Ch. 8 - External Sounders
- Ch. 9 - Magnetic Locks
- Ch. 10 - Elevator Deactivation
- Ch. 11 - Automatic Door Deactivation
- Ch. 12 - Fire Panel Interface (FPI)
- Ch. 13 - Timer
- Ch. 14. - Alert Panels
- Ch. 15 - System Maintenance & Testing
- Ch. 16 - FAQ & Troubleshooting
- Appendix A: Component Cut Sheets
- Glossary
- Index
9-8 Magnetic Locks LC 1200 Manual
3000 Series Magnetic Locks
Specifications
Mounting
Wiring
Specifications
Power Requirements
Temperature
Weight
Power Requirements
12V or 24V AC/DC
Temperature
3000 Magnetic Locks (
Part # 700218) operate
best in an ambient temperature between 35 and
90 degrees Fahrenheit. Operation outside of this
range may cause unexpected or undesirable
results, including premature failure.
Weight
The 3000 Magnetic Lock weighs 9 U.S. pounds.
Mounting
To mount the 3000 Magnetic Lock, follow the
DynaLock Corp. Mounting and Operating
Instructions that came with the Lock.
NOTE: State codes require that all lock and
elevator deactivation circuitry be wired into the
facility’s fire alarm system. This is done so that
in case of a fire, any lock or elevator
deactivation unit disengages, allowing for free
egress or ingress. Be sure to check Local, State
and Federal Codes as well as Chapter 12: Fire
Panel Interface (FPI).
Wiring
You will need 18-gauge, 2-conductor plenum-
rated cable for this connection.
The basic operation of this Lock will center on
supplying power to the Lock coil whenever a
Tag is detected in the zone, and removing that
power when there are no Tags detected in the
zone.
To connect the 3000 Series Magnetic Lock to
the LC unit, refer to Figure 9.4