User's Manual

1-4 The Accutech Systems Installation Manual
closed and a Keypad Reset (or AutoReset
jumper in place) to clear.
A Loiter alarm occurs when a Tag lingers in the
Tx Activation Field. Remove all Tags from the
Field and then enter a Keypad Reset (or
AutoReset jumper in place) to clear this alarm.
A Supervisor alarm occurs when the
performance of the system has been altered due
to tampering or inadvertent acts such as cut
wires, antenna damage or interference, etc. The
alarm will reset when the condition is corrected.
Contact the person outlined in your protocol for
this type of alarm.
NOTE: Receiver-related supervise events can
be reset by the Keypad for the duration of the
supervise interval. This will silence the alarm.
A Band Alarm occurs when the BR42 Tag/band
is removed or tampered with in any way or the
Cut Band Tag/band is cut.
System Components
This section contains a brief description and a
simple graphic (not to scale) for each component
and its role in the Accutech Systems.
NOTE:
Accutech reserves the right to substitute
comparable components.
Since each facility’s system is unique to its
particular needs, check off the components that
your facility’s system has below:
Components
 The ES 2200 System Tag (LT/SB22)
 The IS 3200 System Tag (LT/SB32)
 The BR 4200 System Tag (BR42)
 Cut Band Tag
 Tag barcodes
 Visual Pulse LED
 The Tag Activator Deactivator (TAD)
 The Tag Test Station (TTS)
 The Accutech Software
 The Controller
 The Transmit (Tx) wand antenna
 The Receiver
 The Keypad
 The Push Button Override (PBO)
 The Magnetic Switch
 The Passive Infrared Reader (PIR)
 The Local Alarm
 The Central Alarm
 The Speakers
 The Multiplexer
 Power Supply
 The Staff Alert Panel (SAP)
 The Graphic Display Panel (GDP)
 Magnetic Locks
 Elevator Deactivation Circuitry
 The Fire Panel Interface (FPI)
 Timer