User's Manual

3-2 The Controller Installation Manual
Mounting the Controller at the zone
To mount the Controller, refer to Figure 3.1
and use the following instructions:
1. Mark-out and drill 4 mounting holes
in the wall corresponding to the
mounting holes of the Controller.
2. Using appropriate hardware for the
mounting surface, install the four
anchors, then the upper two screws
leaving about a 1/8
th
of an inch
exposed.
NOTE: The hole spacing on the
Controller is 16” on centers, which
is typical wall stud spacing.
3. Remove the Controller cover.
4. Align the large “key-way” holes
with the upper screws and gently
guide the Controller base onto the
screws allowing the unit to hang
from these screws temporarily.
5. Determine which knock-outs will be
used for bringing the wires and/or
cable into the Controller. Remove
the Controller from the upper
screws, remove the appropriate
knock-outs and install the proper
fittings and/or bushings.
6. The Controller is shipped with an
internally mounted Receiver
(mounted backwards to protect the
antenna connector in shipment).
You will need to flip the Receiver
around.
7. Refer to Figure 3.1 and remove the
two mounting screws that attach the
Receiver to the Controller.
8. Flip the Receiver around and
re-mount it.
NOTE: Be sure to keep the wire
harness connections intact during
this move.
9. Make any and all conduit
connections that require the
Controller to be unmounted.
10. Position the Controller back on the
first two screws and install the last
two mounting screws then tighten
all 4 mounting screws.
11. Punch out the Receiver antenna
knock-out on the Controller cover.
12. Replace the Controller cover and
attach the Receiver antenna.