User's Manual

Installation Manual The Tx wand antenna 4-11
(LED brightness adjust)
counterclockwise until the yellow
LED1 dims then adjust C1 again.
7. After you have finished adjusting, on
the “X” antenna, turn pot R1
completely counterclockwise so that
LED1 is dim.
8. Replace jumper JP6.
9. On the Controller, quickly remove
jumper JP6 (Scan Rate) so that only
LED2 (the “Y” antenna output
indicator) is illuminating. This may
take a few attempts. You will not
leave the jumper in place while
tuning.
10. On the “Y” antenna, adjust C1 until
LED1 lights brightly (
Figure 4.11).
NOTE: The object here is to use the
brightness of LED1 to show when C1
has been adjusted properly. Therefore,
if you try to see a change with LED1
set too bright you may miss that
change and be slightly off tune. If this
is the case, on the antenna, turn pot R1
(LED brightness adjust)
counterclockwise until the yellow
LED1 dims then adjust C1 again.
11. After you have finished adjusting, on
the “Y” antenna, turn R1 completely
counterclockwise so that LED1 is
dim.
12. Replace jumper JP6.
13. On the Controller, quickly remove
jumper JP6 (Scan Rate) so that only
LED3 (the “Z” antenna output
indicator) is illuminating. This may
take a few attempts. You will not
leave the jumper in place while tuning
14. On the “Z” antenna, adjust C1 until
LED1 lights brightly (
Figure 4.11).
NOTE: The object here is to use the
brightness of LED1 to show when C1
has been adjusted properly. Therefore,
if you try to see a change with LED1
set too bright you may miss that
change and be slightly off tune. If this
is the case, on the antenna, turn pot R1
(LED brightness adjust)
counterclockwise until the yellow
LED1 dims then adjust C1 again.
15. After you have finished adjusting, on
the “Z” antenna, turn R1 completely
counterclockwise so that LED1 is
dim.
16. On the Controller, place jumper JP6
(Scan Rate) into position 1-2.
17. On the Controller, return switch S3 to
the left position
18. Replace all antenna covers and secure
them using the spanner screws.
19. Replace the Controller cover and
secure it using the screws.
Alternate Tuning Method
WARNING: The following alternate tuning
method requires more user knowledge about
the Controller because it includes physically
isolating each Tx wand antenna on the
Controller during tuning.