User's Manual

Accutech reserves the right to substitute comparable components without notice.
CUT SHEET: IS 3200 System Tags
IS 3200 System Tags are small wristwatch-sized devices worn by a resident, infant, or attached to an asset. When a resident
or patient enters a Tx Activation Field, the Tag sends a signal to the zone Controller via the Receiver. The zone Controller
processes this information for appropriate control action or response (e.g., sounding alarms, locking doors).
IS 3200 System Tags are assigned to a specific infant via the Tag Test Station and Accutech Software. Once assigned, the
computer associates a name, room number, and any other pertinent information about the infant with that Tag.
Available in a LT (Long Term) case. “22” and “32” refer to the program running inside the Tag. The 22 program is meant
strictly for ES systems. The 32 program can be used in either ES or IS systems and displays a low battery condition.
ELECTRICAL:
IS 3200 System Tags operate by internal battery.
The Tags have been engineered for greater than 12 months usage and
can be activated/deactivated with a TAD.
MECHANICAL:
Size: 1¼” x 1½” x ½”
Weight (with band): 0.5 ounce
OPERATING CHARACTERISTICS:
Transmit Frequency: 418 MHZ
Receive Frequency: 128-133 kHz
ATTACHMENT:
IS 3200 System Tags are attached with a nylon-mesh-reinforced
vinyl band. The band is designed to resist tearing caused by pulling
or chewing on the band. However, if the band becomes frayed or
torn it will need to be replaced. In long-term applications, the band
should be replaced periodically for cleanliness. Tags are typically
attached to a wrist or ankle.
MAINTENANCE:
 IS 3200 System Tags are reusable but they must be thoroughly
cleaned and sanitized between applications.
Acceptable cleaning methods:
Antibacterial wipes or Hydrogen peroxide (wipe, do not soak)
 IS 3200 Tag bands are for one-time use only.
 In long-term applications, periodically replace the bands and
clean the Tags.
TESTING:
There are 3 ways that you can test IS 3200 System Tags:
 Enter a monitored zone (Alarm may sound)
 With a TAD
 With a PTAD
STORING:
Ideally, to preserve battery life and prevent nuisance alarms, IS
3200 System Tags should be turned off
with a TAD, stored away
from sources of electrical noise, and stored in a metal container with
lid. Extra Tag bands should be stored in a clean and dry
environment.
ENVIRONMENTAL:
Operating Temperature: 32º to 120º Fahrenheit
Intended for indoor use only.
UL Listed 294 (BP9480)
Access Control Accessory
Model Number: LTY
Part Number: 77I018 (LTY)
UL Listed 294 (BP9480)
Access Control Accessory
Model Number: SBY
Part Number: 77I016 (SBY)
UL Listed 294 (BP9480)
Access Control Accessory
800-356-2671 | Accutech | www.accutech-ics.com