User's Manual

Accutech reserves the right to substitute comparable components without notice.
CUT SHEET: Tag Test Station (TTS)
The Tag Test Station (TTS) is used for Tag assignments. In a similar fashion to a Tx wand antenna, the TTS emits a small Tx
Activation Field that activates Tags. Once activated a Tag sends a signal to the Receiver. The Receiver sends this
information to the Multiplexer, which sends it to the computer with the Accutech Software. The Tag Reader Status dialog
box appears on the PC screen where it can be assigned or unassigned.
The TTS is connected to a Controller, which is connected to a Multiplexer.
ELECTRICAL:
Operating Voltage: 30V AC (provided by Controller)
Cable: required minimum 18-gauge, 2-conductor
MECHANICAL:
Size: 5.00” x 7.00” x 1.50”
Weight: 10 ounces
OPERATING CHARACTERISITICS:
Transmits at 132 Khz continuously
ENVIRONMENTAL:
Operating Temperature: 32º to 120º Fahrenheit
Intended for indoor use only.
DUTY CYCLE:
Rated for continuous use.
Tag Test Station (TTS)
Part Number:
700010 (I)
700020 (R)
800-356-2671 | Accutech | www.accutech-ics.com