User's Manual
Installation Manual the Accutech Software 19-1
The Accutech Software
Minimum System Requirements
Recommended System Components
Installing the Accutech Software
Uninstalling the Accutech Software
Example System Configuration
The Accutech Software (v4.10 or greater)
displays incoming event information via the
Multiplexer from monitored zones. The PC
screen will display events in real-time using the
facility’s floor plan as the background.
The Accutech Software is separate from and
does not affect or control the physical Accutech
security system.
Minimum System Requirements
Intel Celeron 400mHz
17” Monitor (capable of displaying
1024x768 pixels in 16-bit high color
8.4 GB Hard Drive
64MB PC-100 SDRAM
8MB AGP Video Card
Sound Card
Speakers
3 ½ “ Floppy Drive
24x CD-ROM Drive (minimum available)
Motherboard w/Intel BX or VIA 133
Chipset (should be expandable, i.e., 3 PCI,
1 ISA, 1 ASP. 2 Serial, 2 USB, 1 parallel
Keyboard
Mouse
Mouse Pad
Windows NT, Me, 2000 or XP
If this is a Networked System, you will
need a Network Interface Card (NIC).
Accutech recommends a 3Com PCI NIC.
1 Serial 9pin COM PORT
Recommended System Components
Pentium 4 Processor 1.8 GHz
128 MB PC-133 SDRAM
16 MB Video Card
16-bit PCI Sound Card
Windows 2000
Windows Service Pack 2 or higher
Installing the Software
NOTE: Windows 2000 users will need
Administrator privileges to install the software.
1. Close all other applications before
installing the Accutech Software.
2. Place the Accutech CD in your
CD-ROM drive.
3. If Autoplay is enabled, the installation
program will begin.
4. If Autoplay is not enabled:
a. From the Start menu, Settings,
select Control Panel.
b. Double-click “Add/Remove
Programs”.
c. Click “Add New Programs”.
NOTE: Windows Me users,
click “Install”.
d. Click “CD or Floppy”.
e. Click “Next”.
f. Click “Finish”.
5. In the Accutech installer, follow the on-
screen instructions to accept all default
settings.
6. When prompted, reboot your computer
to complete installation.