User's Manual

22-2 User-Defined Settings Installation Manual
Loiter Reset
JP10 determines if the Loiter alarm
automatically resets once the Tag leaves the
zone.
Table 22.4 JP10
Position Alarm Automatically Resets?
In Yes
Out No
System Supervise
JP5 determines how often the System Supervisor
checks the Accutech System. For more
information about the System Supervisor, see
page 3-6.
Table 22.5 JP5 Positions and Results
Position
Result
(Check system Once/Time Interval)
1 Test
(testing purposes only)
2 Demo; Once/min
(demonstration purposes only)
3 Once/ 2 Hours
4 Once/ 4 Hours
5 Once/ 8 Hours
6 Once/16 Hours
7 Disable
Power Loss Supervise
The Controller has a Power Loss Supervise
function that will indicate that the system power
has been lost. For complete information about
this function, see page 3-7.