User's Manual

Installation Manual Appendix A: Discontinued Components A-1
Appendix A:
Discontinued Components
From time to time, system components may
become discontinued due to revisions,
improvements, or unavailability from the
manufacturer.
 ES 2100 Receiver
 Composite Cable (Part #200355)
 Tag styles (gray and yellow colored)
ES 2100 Receiver
 Receiver Specifications
 Internal vs. External Receivers
 Receiver Mounting Options
 Receiver Positioning/Stagger Tuning
 Connecting the Receiver
 Adjusting the Receiver
NOTE:
The ES 2100 Receiver is a special
order item only; it is no longer in production
and is replaced with an IS 3200 Receiver.
The ES 2100 Receiver (Figures A.1-A.2) located
at the monitored zone, picks up the signal from
an activated Tag and relays it to the Controller.
Zone Receivers can be internally or externally
mounted near a monitored zone.
Receiver Specifications

Power Requirements
 Temperature
 Weight
Power Requirements
6V DC
Temperature
Receivers operate best in an ambient
temperature between 35 and 90 degrees
Fahrenheit. Operation outside of this range may
cause unexpected or undesirable results,
including premature failure.
Weight
Internal and External Receivers weigh
approximately 5.0 oz. and 1 lb. 5.0 oz. U.S.
respectively, which should be considered when
choosing mounting hardware.
Figure A.1
Internally mounted ES 2100 Receiver
Figure A.2
Externally mounted ES 2100 Receiver