User's Manual

A-8 Appendix A: Discontinued Components Installation Manual
Activating/Deactivating Tags
NOTE: The “Tag Signal Strength” LEDs of the
TAD (
see Figure A.10) indicate the current state
of a Tag. Illuminated indicates the Tag is on
;
dormant indicates the Tag is off
or is not
functioning.
1. With no Tag in the TAD, slide the
Power switch to the On position
The TAD Power LED illuminates.
If not, replace the TAD 9-volt battery
and turn on the TAD.
NOTE: If a Tag is in the receptacle and
the power to the TAD is cycled, the Tag
may be turned on or off unintentionally.
2. Place the Tag into the tag receptacle on
the back of the TAD unit in proper
orientation for the Tag type (
see Figure
A.11
)
NOTE: If the “Tag Signal Strength”
LEDs illuminate, the Tag is on
. If the
“Tag Signal Strength” LEDs do not
illuminate, the Tag is off
.
3. To change the state of a Tag
(from either on
to off or off to on),
press and release the TAD button
The WAIT LED will illuminate for about
a second.
The “Tag Signal Strength” LEDs will
change according to the state change
(illuminating for on
, dormant for off).
Figure A.10: The TAD front label
NOTE:
The Power switch for your TAD may be
located on the left side or top of the unit.
Figure A.11: Proper Tag Orientation