User's Manual

FOR OFFICIAL USE ONLY 8
Figure 6 – Coyote UGS LED Status Indicator Field Guide
4. Deactivation Procedure
A Coyote UGS node can be deactivated after it has been activated by following a simple procedure that turns it
off. This procedure is virtually identical to the activation procedure.
4.1. Deactivation Steps
The deactivation steps require no additional equipment or tooling.
5) The first step is to hold the Coyote UGS node flat and hold this position for 3 seconds.
6) The second step is to rotate the Coyote UGS node 90 degrees to the EAST* and hold this position for 3
seconds.
7) The third step is to rotate the Coyote UGS node 180 degrees to the WEST and hold this position for 3
seconds.
8) The last step is to return the Coyote UGS node to a flat position and hold this for 3 seconds.
* Note – The NORTH bearing is relative to the “N” arrow on top of Coyote UGS housing
The Coyote Deactivation Field Guide lists these steps and is accompanied by images of the Coyote UGS nodes
for ease of use in the field. This can be seen in Figure 7.