User's Guide

Revised: 11/24/2020 6650-20-0014, Rev. A
Approval: Page 3 of 13
1. INDOOR LOCATION BEACON OVERVIEW
Innovative Wireless Technologies’ FAP5030-030 Indoor Location Beacon (ILB) is a PoE powered device
containing a Wi-Fi AP and a Bluetooth® Low Energy (BLE) beacon that can be used to provide enhanced
location support for indoor facilities. An internal configuration webpage allows the Wi-Fi and
Bluetooth® parameters to be configured from a laptop/tablet/phone.
2. SAFETY INFORMATION
IMPORTANT! READ BEFORE USING THE INTEGRATED MESH NODE
This section contains important information on the safe operation of the IMN.
2.1 DEVICES INSTALLED ABOVE GROUND
NOTE: FCC CERTIFICATION PENDING
2.1.1 Part 15 of Federal Communications Commission (FCC) Rules Compliance
This device complies with Part 15 of FCC Rules. Operation is subject to the following two conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference that may cause
undesired operation.
This device contains FCC ID: 2AJVP-OMEGA2
FCC ID: PENDING
When operated above ground, ILB professional installation is required. No external antennas are
approved for use with this product.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of FCC rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses, and can radiate RF
energy which may cause harmful interference to radio communications if not installed and used in
accordance with the instructions. It is important to note that proper installation does not guarantee
interference will not occur. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
reorient or relocate the receiving antenna;