User's Manual

1.26.21 357-00031-01 Rev A © Inovonics, 2021 - www.inovonics.com
Mobile Duress Pendant Family
Installation Instructions
1 Overview
The Inovonics mobile duress pendant is designed to provide indoor room
and floor level location with a button press. Inovonics mobile duress
pendants are only available to factory trained dealers and only compatible
with the EN7295 mobile duress gateway and EN5060 locators.
The mobile duress pendant is available in the following configurations:
Inovonics mobile duress pendants are shipped in bulk packaging so that
orders can be fulfilled by removing pendants and batteries from packaging
based on order quantity. Single pendant orders may be repackaged
separately. To re-close the box after batteries are inserted into pendants,
remove battery compartment divider at perforation along hinge.
1.1 Inovonics Contact Information
If you have any problems with this procedure, contact Inovonics technical
support:
• E-mail: [e-mail].
• Phone: [phone].
1.2 Pendant Transmitter Components
Figure 1 Pendant Transmitter components
2 Installation and Startup
2.1 Installation Notes
• These products are designed to be installed and maintained by
professional security technicians.
• Products are intended for indoor use.
• Manually test all products weekly.
2.2 Install the Battery
1. Pry the housing apart at either end and pull the two halves apart.
2. Install the battery.
Caution: Ensure that a new Panasonic CR2 or equivalent battery is always
installed in the mobile duress pendant. Never install a used battery.
3. Press the reset button to initialize the transmitter.
3 Register mobile duress pendants
All mobile duress pendants must be registered with the system in order to
be used, monitored and supervised. When supervised, the mobile duress
pendants will send check-in message to the Inovonics gateway.
Note: These instructions cover installation and operation of the mobile
duress pendant. Please refer to the Inovonics Mobile Duress User Manual
for instructions about registering pendants to a specific site’s mobile duress
system. Please contact support or your account manager if you do not
have a copy of the user manual.
4 Operation
4.1 Using The EN2233 Pendant Chain
Always use the chain included with the EN2233. Substituting stronger
cords or chains may result in injury to the wearer.
4.2 Converting a Belt Clip Pendant to a Belt Loop
If you’d like to convert a belt clip pendant transmitter belt clip to a belt loop,
secure the bottom of the belt clip to the housing with a coarse thread screw.
Figure 2 Use a coarse thread screw to secure the belt clip
Part # Type Buttons Conditions
EN2224 Belt clip Four Fifteen
EN2233D Necklace Two One
EN2233S Necklace One One
EN2235D Belt clip Two One
EN2235S Belt clip One One
EN2236D Belt clip Two Three
EN2238D Belt clip Two Two
For product and installation videos visit us at
www.inovonics.com/videos or use the QR
code below.
A Reset button B Battery
A
B