Installation Guide

TRM Module Installation Guide
10/16/19 357-00020-01 Rev A
Overview
The TRM Module is a highly reliable, frequency hopping, spread-spectrum radio transceiver that operates
within the 902 to 928 MHz license-free band. In order to ensure proper integration into the final product
and maintain compliance with the rules and regulations under which this module has been granted
certification, the requirements listed below must be followed.
Compliance Requirements:
The TRM Module complies with FCC, Title 47, Chapter 1, Subchapter A, Part 15, Subpart C, Section 15.212
(a)(1)(i through viii). The final host/module combination may also need to be evaluated against the FCC
Part 15B criteria for unintentional radiators in order to be properly authorized for operation as a Part 15
digital device.
Additional Compliance Information per FCC 47 CFR, Section 2.1077:
1. Product Identification TRM (Transmitter-Receiver Module)
2. The TRM module is in compliance with 47 CFR, Section 15.19(a)(3) as follows:
Operation is subject to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
3. Responsible party for Supplier’s Declaration of Conformity:
a. Name of Responsible Party: Inovonics Corporation
b. Address of Responsible Party: 397 S. Taylor Ave., Louisville, CO 80027
c. Telephone Numbers: (800) 782-2709; (303) 939-9336
d. E-mail: support@inovonics.com
- The TRM Module is intended only for use in products installed and maintained by professional security
technicians.
- Manually test all TRM Module based products weekly.
NOTE: It is Inovonics policy to maintain complete control of all firmware associated with this device.
- The TRM Module can operate only with the built-in antenna.
- When installed in a host’s end-device, the antenna must maintain a minimum separation distance of 20
cm from all persons.
- In accordance with FCC multi-transmitter product procedures, the TRM module must not transmit
simultaneously with any other co-located antenna or transmitter.
- The TRM Module does not contain any user serviceable components.
- A label must be affixed to the outside of the host product with the following statements:

Summary of content (4 pages)