Installation Guide

TBA Module Installation Guide
08/11/22 357-00062-01 Rev A
Overview
The TBA module is a highly reliable, frequency hopping, spread-spectrum radio transceiver that operates
within the 902 to 928 MHz license-free band. In order to ensure proper integration into the final product
and maintain compliance with the rules and regulations under which this module has been granted
certification, the requirements listed below must be followed.
Compliance Requirements:
The TBA module complies with FCC, Title 47, Chapter 1, Subchapter A, Part 15, Subpart C, Section 15.212
(a)(1)(i through viii). The final host/module combination may also need to be evaluated against the FCC
Part 15B criteria for unintentional radiators in order to be properly authorized for operation as a Part 15
digital device.
Additional Compliance Information per FCC 47 CFR, Section 2.1077:
1. Product Identification – TBA (T = Transmitter-Receiver Module; B = Second generation TRM; A =
First FCC/IC revision)
2. The TBA module is in compliance with 47 CFR, Section 15.19(a)(3) as follows:
Operation is subject to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
3. Responsible party for Supplier’s Declaration of Conformity:
a. Name of Responsible Party: Inovonics Corporation
b. Address of Responsible Party: 11000 Westmoor Dr, Building 10, Suite 250, Westminster
CO 80021
c. Telephone Numbers: [phone]; [phone]
d. E-mail: [e-mail]
- The TBA module is intended only for use in products installed and maintained by professional security
technicians.
- Manually test all TBA module based products weekly.
NOTE: It is Inovonics policy to maintain complete control of all firmware associated with this device.
- The TBA module can operate only with the built-in ceramic chip antenna.
- When installed in a host’s end-device, the antenna must maintain a minimum separation distance of 20
cm from all persons.
- In accordance with FCC multi-transmitter product procedures, the TBA module must not transmit
simultaneously with any other co-located or transmitter, except in accordance with FCC multi-transmitter
product procedures.