User's Guide

Inpixon Doc No. INPX-DOC Rev.1.2
User Guide, UWB Module– INPX-400
Dated: July 22, 2020
The content of this document is to be treated as strictly confidential and is not to be disclosed,
Reproduced or used, except as authorized in writing by Inpixon
Copyright © 2020 Inpixon
Page 5 of 8
Antenna Consideration
4.2.1 Antenna Selection
Inpixon UWB Module’s antenna is tuned for 3.5GHz to 6.5Ghz frequency ranges, with peak gain of
5dBi, and efficiency of more than 70% across the bands. Inpixon UWB Module must be used together
with the antenna certified.
4.2.2 RF Exposure Consideration
Host Product Manufacturer must provide RF exposure statements and use conditions in their end-
product manuals. If RF exposure statements and use conditions are not provided, then the host product
manufacturer is required to take responsibility of the module through a change in FCC ID.
Host Product Manufacturer Notice
Th modular transmitter is only FCC authorized for the specific rule parts listed on the grant (47 CFR Part
15 Subpart F), and that the host product manufacturer is responsible for compliance to any other FCC
rules that apply to the host not covered by the modular transmitter grant of certification. If the host product
manufacturer markets their product as being Part 15 Subpart B compliant (when it also contains
unintentional-radiator digital circuity), then the host product manufacturer shall provide a notice stating
that the final host product still requires Part 15 Subpart B compliance testing with the modular transmitter
installed.
In addition, Host Product Manufacturer must comply with the following regulations:
1. The INPX-400 modular transmitter must be labeled with its own FCC ID number, and, if the FCC ID is not
visible when the module is installed inside another device, then the outside of the device into which the
module is installed must also display a label referring to the enclosed module.
2. This exterior label can use wording such as the following:
IMPORTANT: Contains FCC ID: 2AVTI-INPX400. This equipment complies with Part 15 of the FCC
Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful
interference, and (2) this devise must accept any interference received, including interference that may
cause undesired operation.
4.3.1 OEM Integrator Text
This device is intended only for OEM integrators under the following conditions: The module must be
installed in the host equipment such that the antenna(s) used for this transmitter must be installed to
provide a separation distance of at least 5mm from all persons and must not be co-located or operating
in conjunction with any other antenna or transmitter.
The module shall be only used with the antenna that has been originally tested and certified with this
module. Antenna shall not be modified. However, the OEM integrator is still responsible for testing their
end‐product for any additional compliance requirements required with this module installed (for