Users Manual
詈
FCC RF Exposure Information and Statement
This device meets the government's requirements forexposure to radio waves. The
guidelines are based onstandards that were developed by independent
scient
ificorganizations through periodic and thorough evaluation of scientific
studies. The standards include a substantial safety margin designed to assure the
safety of all personsregardless of age or health. The SAR limit of USA (FCC) is 1.6
W/kg averaged.Device types: Intelligent Two Way Radio (FCC ID: 2AIV6-T522A)
hasalso been tested against this SAR limit. SAR information on this and other pad
can be viewed on‐line at http://www.fcc.gov/oet/ea/fccid/. Please use the device FCC
ID number for search. This device was tested simulation typical 0mm to body and 25
mm front of face. To maintain compliance with FCC RF exposure requirements, use
accessories should maintain a separation distance between the user's bodies
mentioned above. the use of belt clips, holsters and similar accessories should not
contain metallic components in its assembly, the use of accessories that do not
satisfy these requirements may not comply with FCC RF exposure.
FCC Warning
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful interference, and (2) This device must accept
any interference received, including interference that may cause undesired operation.
NOTE 1: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
NOTE 2: Any changes or modifications to this unit not expressly approved by the
party responsible for compliance could void the user's authority to operate the
equipment.
,
wbbq
,
bw
:
-R.
-bwq
.
-Cq
w
.
-Cx/TV
.
NTE2:
xbb
'
q.