Installation Manual

Next, you must connect the backup trigger wire, labelled
“REVERSE” on the main wiring harness. This triggers the JK2001
to immediately display the feed from the camera, when the
vehicle is backing up.
25
When this wire is connected, your JK2001 will automatically
display the backup camera anytime the vehicle is in reverse.
Note that If you see a “No signal” warning when you’re backing
up, ensure that the backup video feed is connected to “CAM IN”
RCA port and the power wires are properly connected.
If nothing happens (the camera does not display or you do not
get a “No signal” warning) then check that the metals are
securely contacting in the REVERSE trigger connection pictured
above. If you’ve checked that and still aren’t getting a
response, then you may fall in a small percentage of Jeep
owners that need an additional step. In that case, contact
[e-mail]
for further instruction.
Appendix A: Installing cameras