Warranty
Table Of Contents
- About your BPC100
- Setting up your BPC100
- Step 1: Transfer your phone number
- Step 2: Install backup batteries for use during power outage
- Step 6: Make calls
- Step 3: Install the power adapter
- Step 4: Connect your telephone to the BPC100
- Find more information
- 800.922.0204.
- Warning
- This device complies with Industry Canada’s licence-exempt RSSs. Operation is subject to the following two conditions: (1) This device may not cause interference; and (2) This device must accept any interference, including interference that may cause ...
- Cetappareilestconforme aux CNR exempts de licenced'Industrie Canada. Son fonctionnementestsoumis aux deux conditions suivantes : ( 1 ) Ce dispositif ne peut causer des interférences ; et ( 2 ) Ce dispositifdoit accepter touteinterférence , y compris l...
- This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installatio...
- -- Reorient or relocate the receiving antenna.
- -- Increase the separation between the equipment and receiver.
- -- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- -- Consult the dealer or an experienced radio/TV technician for help.
- This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
- Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
- The antenna(s) used for this transmitter must be installed to provide a separation distance of at least 30 cm from all persons and must not be co-located or operating in conjunction with any other antenna or transmitter.
Warning
This device complies with Industry Canada’s licence-exempt RSSs.
Operation is subject to the following two conditions: (1) This device
may not cause interference; and (2) This device must accept any
interference, including interference that may cause undesired
operation of the device.
Cetappareilestconforme aux CNR exempts de licenced'Industrie
Canada. Son fonctionnementestsoumis aux deux conditions suivantes :
( 1 ) Ce dispositif ne peut causer des interférences ; et ( 2 ) Ce
dispositifdoit accepter touteinterférence , y compris les interférences
qui peuvent causer un mauvaisfonctionnement de l'appareil.
This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is
subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this
device must accept any interference received, including interference
that may cause undesired operation.
Changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate
the equipment.
The antenna(s) used for this transmitter must be installed to provide
a separation distance of at least 30 cm from all persons and must not
be co-located or operating in conjunction with any other antenna or
transmitter.
Note: The telephone and telephone cord are not included.