User's Guide
Table Of Contents
- Contents
- 1 Introduction and Getting Started
- 2 Admin User Interface
- 3 Troubleshooting and Support
- 4 Product Specifications and Regulatory Information
- 5 Glossary
![](/manual/inseego/isgfw2010/user-s-guide-english/images/img-18.png)
5G OUTDOOR MODEM FW2010 USER GUIDE 23
Viewing Info About the FW2010
On the Web UI Home page, the General Status panel shows general Internet connection and system
information.
Carrier: The name of the Mobile Network Operator.
Technology: Indicates the current cellular data connection, for example, 5G Sub6.
Band: The cellular network band in use for the current connection.
PCI: The Physical Cell ID that indicates the cellular tower/node to which the device is connected.
SIM Status: The current status of the SIM card.
WAN Status: The current status of the WAN connection.
MDN: The phone number of your FW2010.
IMEI: The International Mobile Equipment Identity (IMEI) for your FW2010. This is a 15 digit code used
to uniquely identify an individual device. The IMEI does not change when the SIM is changed.
Signal Strength (RSRP): The strength of the cellular signal, measured in dBm. Higher absolute values
indicate a stronger signal, for example: -80 dBm is a stronger signal than -90 dBm.
SINR: Signal to Interference plus Noise Ratio. An LTE-specific measure of signal quality, taking
interference and noise into account. SINR is a positive value, and higher numbers are better.
FW Version: The version of the firmware (software) currently installed on your FW2010.
IPv4: The network IP address assigned to your computer, not your FW2010 device.