User's Guide

5G OUTDOOR MODEM FW2010 USER GUIDE 41
WARNING: DO NOT ATTEMPT TO SERVICE THE WIRELESS COMMUNICATION DEVICE YOURSELF.
SUCH ACTION MAY VOID THE WARRANTY. THIS DEVICE IS FACTORY TUNED. NO CUSTOMER
CALIBRATION OR TUNING IS REQUIRED. CONTACT INSEEGO CORP TECHNICAL SUPPORT FOR
INFORMATION ABOUT SERVICING YOUR WIRELESS COMMUNICATION DEVICE.
FCC CAUTION: Any changes or modification not expressly approved by the party responsible for
compliance could void the user's authority to operate this equipment.
MODIFICATIONS: The FCC requires that you be notified that any changes or modifications made to
this device that are not expressly approved by Inseego Corp. may void your authority to operate the
equipment.
NOTE: The Radio Frequency (RF) emitter installed in your modem must not be located or operated in
conjunction with any other antenna or transmitter, unless specifically authorized by INSEEGO CORP.
Innovation, Science and Economic Development Notice (ISED – Canada)
IC: 3229A-FW2010
ISED RSS-Gen Notice
This device contains license-exempt transmitter(s)/receiver(s) that comply with Innovation,
Science and Economic Development Canada’s license-exempt RSS(s). Operation is subject to the
following two conditions:
1. This device may not cause interference.
2. This device must accept any interference, including interference that may cause
undesired operation of the device.
L’émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR
d’Innovation, Sciences et Développement économique Canada applicables aux appareils radio
exempts de licence. L’exploitation est autorisée aux deux conditions suivantes:
1.
L’appareil ne doit pas produire de brouillage.
2. L’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est
s
usceptible d’en compromettre le fonctionnement.
ISED Canada ICES-003 Compliance
CAN ICES-3 (B)/NMB-3(B)
FCC RF Exposure Guidance Statement
In order to comply with FCC RF Exposure requirements, this device must be installed to provide at
least 150 cm separation from the human body at all times.
Afin de se conformer aux exigences d'exposition RF FCC / ISED, cet appareil doit être installé pour
fournir au moins 150 cm de séparation du corps humain en tout temps.