User's Guide
Table Of Contents
- Cover Page
- Contents
- 1 Introduction and Getting Started
- 2 Touchscreen
- 3 Admin Website
- 4 Advanced Settings
- 5 Troubleshooting and Support
- Overview
- Common Problems and Solutions
- My M2000 powered off without pressing the Power button
- No service is available
- My M2000 has no power/touchscreen doesn’t display when I press the Power button
- I forgot my Wi-Fi password
- I forgot my M2000 Admin website password
- I cannot connect a device to my M2000
- I see the network name, but cannot connect a device to my M2000
- I want to see how many devices are connected
- I want to see the firmware (software) version installed on my M2000
- I want to see the phone number for my M2000
- I want to see the battery level of my M2000
- I want to turn my M2000 off
- I want to know if my M2000 is still on when the touchscreen is dark
- Technical Support
- 6 Product Specifications and Regulatory Information
- 7 Glossary
5G MiFi M2000 USER GUIDE 70
Mac Filter Tab
The MAC filter allows only selected devices to access the M2000 primary Wi-Fi network. By default,
MAC filter is turned OFF.
Use this tab to turn the MAC Filter ON and specify device access.
NOTE: The MAC filter has no effect on devices connected to the guest Wi-Fi network or devices
connected via USB.
MAC Filter
To use the MAC filter, select the device(s) from the device list that you want to be allowed to connect
to the primary network and move the ON/OFF slider to ON. Click Save Changes.
CAUTION: Turning on MAC filtering immediately disconnects all devices that are not included in the
filter from the primary network.
Device List
This list includes all devices currently connected to the M2000, except those connected via USB.
Add new device: Use this button to add a device to the device list, then enter the device name, MAC
address, choose whether to select the MAC Address Filter checkbox, and click Save Changes.
To delete a device from the list, select its Delete checkbox and click Save Changes.
To discard any unsaved changes and refresh the list, click Refresh list and Confirm.