User's Guide
Table Of Contents
- Cover Page
- Contents
- 1 Introduction and Getting Started
- 2 Touchscreen
- 3 Admin Website
- 4 Advanced Settings
- 5 Troubleshooting and Support
- Overview
- Common Problems and Solutions
- My M2000 powered off without pressing the Power button
- No service is available
- My M2000 has no power/touchscreen doesn’t display when I press the Power button
- I forgot my Wi-Fi password
- I forgot my M2000 Admin website password
- I cannot connect a device to my M2000
- I see the network name, but cannot connect a device to my M2000
- I want to see how many devices are connected
- I want to see the firmware (software) version installed on my M2000
- I want to see the phone number for my M2000
- I want to see the battery level of my M2000
- I want to turn my M2000 off
- I want to know if my M2000 is still on when the touchscreen is dark
- Technical Support
- 6 Product Specifications and Regulatory Information
- 7 Glossary
5G MiFi M2000 USER GUIDE 73
Start DHCP Address Range at: The start of the IP address range used by the DHCP server. If the IP is
set on the client device, use an IP address outside of this DHCP range; if the IP address is set using an IP
reservation, it will usually be inside this range. NOTE: Only expert users should change this setting.
End DHCP Address Range at: The end of the IP address range used by the DHCP server. If the IP is set
on the client device, use an IP address outside of this DHCP range; if the IP address is set using an IP
reservation, it will usually be inside this range. NOTE: Only expert users should change this setting.
IPv6
Turn on IPv6: Check this box if any of your connected devices support IPv6. This enables IPv6
connected devices to make IPv6 connections to the Internet.
Link-Local Address: The Link-Local IPv6 address if the connected device supports IPv6.
Click Save Changes to activate and save new settings.