User's Guide
Table Of Contents
- Cover Page
- Contents
- 1 Introduction and Getting Started
- 2 Touchscreen
- 3 Admin Website
- 4 Advanced Settings
- 5 Troubleshooting and Support
- Overview
- Common Problems and Solutions
- My M2000 powered off without pressing the Power button
- No service is available
- My M2000 has no power/touchscreen doesn’t display when I press the Power button
- I forgot my Wi-Fi password
- I forgot my M2000 Admin website password
- I cannot connect a device to my M2000
- I see the network name, but cannot connect a device to my M2000
- I want to see how many devices are connected
- I want to see the firmware (software) version installed on my M2000
- I want to see the phone number for my M2000
- I want to see the battery level of my M2000
- I want to turn my M2000 off
- I want to know if my M2000 is still on when the touchscreen is dark
- Technical Support
- 6 Product Specifications and Regulatory Information
- 7 Glossary
5G MiFi M2000 USER GUIDE 76
Start Port: Enter the beginning of the range of port numbers used by outgoing traffic for the
custom application being added.
End Port: Enter the end of the range of port numbers used by the application.
NOTE: If the application uses a single port instead of a range, type the same value for both the
Start Port and the End Port.
Protocol: Select the protocol used by the port range from the drop-down list (TCP, UDP, or
both).
Delete: Check this box to delete a custom application. NOTE: Click on the Port Filtering tab
again to remove deleted custom applications from view on the screen.
Click Save Changes to save any changes made to the custom applications.