User's Guide
Table Of Contents
- Contents
- 1 Introduction and Getting Started
- 2 Software Configuration
- 3 Advanced Settings
- 4 Product Specifications and Regulatory Information
- Product Specifications
- Regulatory Information
- Federal Communications Commission Notice (FCC – United States)
- Innovation, Science and Economic Development Notice (ISED – Canada)
- ISED Canada ICES-003 Compliance
- FCC and ISED RF Exposure Guidance Statement
- Cellular External Antenna Considerations:
- RF Radiation Exposure Guidance Statement
- Radio Frequency and Transmitted Output Power Information
- Product Certifications and Supplier’s Declarations of Conformity
- Wireless Communications
- Limited Warranty and Liability
- Safety Hazards
- 5 Glossary
5G INDUSTRIAL GATEWAY S2000e USER GUIDE 15
Connecting Devices to the Gateway
You can connect to the S2000e gateway with Ethernet, USB, or digital I/O.
Connecting Devices with Ethernet
You can connect to a device via Ethernet.
1. Plug one end of an Ethernet cable into the Ethernet port on the S2000e.
2. Plug the other end of the cable into the Ethernet port of the device you wish to connect.
NOTE: If you are connecting devices via Ethernet using your S2000e as a Dynamic Host Configuration
Protocol (DHCP) server on a switch, select Setting> Advanced > LAN to view and configure DHCP
settings.
Connecting Devices with USB
You can tether to a device with the USB-C port.
1. Connect the USB-C end of a USB cable into the USB-C port on the S2000e. Or, connect a wireless
USB-C adapter
2. Connect the USB-A end of a USB cable into the device you wish to connect.
Connecting I/O Devices
You can use the configurable digital GPIO pins to provide on/off data and functionality.
I/O inputs convey information to the S2000e about the state of an external device or system, or can
provide Ignition Sense.
I/O outputs are used for the S2000e to tell a device or system to turn on or off.
Connecting to the Web UI
Once your S2000e is connected to a network with a device that supports Web browsing, you can use the
Web User Interface to customize settings, change your password, and access information.
On a device connected to the S2000e, open any Web browser and go to http://192.168.1.1 .
Select Sign In (in the top-right corner of the screen), and enter the Admin password printed on the label
of the S2000e.