User's Guide
Table Of Contents
- Contents
- 1 Introduction and Getting Started
- 2 Software Configuration
- 3 Advanced Settings
- 4 Product Specifications and Regulatory Information
- Product Specifications
- Regulatory Information
- Federal Communications Commission Notice (FCC – United States)
- Innovation, Science and Economic Development Notice (ISED – Canada)
- ISED Canada ICES-003 Compliance
- FCC and ISED RF Exposure Guidance Statement
- Cellular External Antenna Considerations:
- RF Radiation Exposure Guidance Statement
- Radio Frequency and Transmitted Output Power Information
- Product Certifications and Supplier’s Declarations of Conformity
- Wireless Communications
- Limited Warranty and Liability
- Safety Hazards
- 5 Glossary
5G INDUSTRIAL GATEWAY S2000e USER GUIDE 17
Indicator LEDs Resetting your Gateway
This section provides information on general care and restoring your S2000e to factory default settings.
You can reset your S2000e to factory settings using the RESET button on the device or from the Admin
Web UI.
CAUTION! Resetting returns your S2000e to factory settings.
Resetting with the RESET Button
The master reset button is in a small hole located in the SIM compartment on the back of the device.
This button returns the device to factory settings, including resetting the admin password
.
To reset the S2000e:
1. Remove the SIM cover.
2. Place one end of an unfolded paper clip into the master reset button hole.
To restart the S2000e: Press the paper clip on the button for three to five seconds. The S2000e
will restart.
To restore the S2000e to factory default settings: Press and hold the RESET button for over
five seconds. This resets all settings to their factory default values.
Resetting from the Admin Web UI
To reset the S2000e from the Admin Web UI, select Settings > Backup and Restore and select Restart
Device to restart the S2000e, or Restore Factory Defaults to reset all settings to their factory default
values.