User's Guide
Table Of Contents
- Contents
- 1 Introduction and Getting Started
- 2 Software Configuration
- 3 Advanced Settings
- 4 Product Specifications and Regulatory Information
- Product Specifications
- Regulatory Information
- Federal Communications Commission Notice (FCC – United States)
- Innovation, Science and Economic Development Notice (ISED – Canada)
- ISED Canada ICES-003 Compliance
- FCC and ISED RF Exposure Guidance Statement
- Cellular External Antenna Considerations:
- RF Radiation Exposure Guidance Statement
- Radio Frequency and Transmitted Output Power Information
- Product Certifications and Supplier’s Declarations of Conformity
- Wireless Communications
- Limited Warranty and Liability
- Safety Hazards
- 5 Glossary
5G INDUSTRIAL GATEWAY S2000e USER GUIDE 32
GPS Local Sub Tab
Use this tab to enable GPS streaming to client devices on the local network. Raw GPS data is provided
by the S2000e in the form of a National Marine Electronics Association (NMEA) text stream. You can
use third-party applications to utilize or forward the GPS data to a remote server.
Turn on Local GPS: Check this box to turn on GPS streaming on the local network.
Global/TAIP ID: You can enter a 4-digit ID that is inserted into your GPS packet for routing to servers,
identifying your S2000e. If left blank, the ID is left off the local broadcast.
Network Protocol: Select the protocol to use for local GPS streaming from the drop-down (TCP or
UDP).
• Store and Forward: If there is an interruption in the WAN interface, the system can store
packets and forward them once the WAN interface connection returns. If you select TCP as the
Network Protocol, you can check the Store and Forward box if you want the system to store
and forward packets.
• IP Address: If you select UDP as the Network Protocol, the IP Address field appears.