User's Guide
Table Of Contents
- Contents
- 1 Introduction and Getting Started
- 2 Software Configuration
- 3 Advanced Settings
- 4 Product Specifications and Regulatory Information
- Product Specifications
- Regulatory Information
- Federal Communications Commission Notice (FCC – United States)
- Innovation, Science and Economic Development Notice (ISED – Canada)
- ISED Canada ICES-003 Compliance
- FCC and ISED RF Exposure Guidance Statement
- Cellular External Antenna Considerations:
- RF Radiation Exposure Guidance Statement
- Radio Frequency and Transmitted Output Power Information
- Product Certifications and Supplier’s Declarations of Conformity
- Wireless Communications
- Limited Warranty and Liability
- Safety Hazards
- 5 Glossary
5G INDUSTRIAL GATEWAY S2000e USER GUIDE 34
GPS Remote Sub Tab
Use this tab to configure the system to stream GPS data to remote servers. NOTE: These servers are
not Inseego Connect. Use Settings > Advanced > Inseego Connect to enable Inseego Connect
remote servers.
Turn on Remote GPS: Check this box to turn on GPS streaming to remote servers.
Global Device/TAIP ID: A 4-digit ID identifying your S2000e that is inserted into your GPS packet for
routing to remote servers. By default this is 1234.
GPS Remote Server Configurations
Add Remote Server: Use this button to add a remote server. The Add new server details dialog
appears.