User's Guide
Table Of Contents
- Contents
- 1 Introduction and Getting Started
- 2 Software Configuration
- 3 Advanced Settings
- 4 Product Specifications and Regulatory Information
- Product Specifications
- Regulatory Information
- Federal Communications Commission Notice (FCC – United States)
- Innovation, Science and Economic Development Notice (ISED – Canada)
- ISED Canada ICES-003 Compliance
- FCC and ISED RF Exposure Guidance Statement
- Cellular External Antenna Considerations:
- RF Radiation Exposure Guidance Statement
- Radio Frequency and Transmitted Output Power Information
- Product Certifications and Supplier’s Declarations of Conformity
- Wireless Communications
- Limited Warranty and Liability
- Safety Hazards
- 5 Glossary
5G INDUSTRIAL GATEWAY S2000e USER GUIDE 36
GPIO Tab
The S2000e includes configurable digital General Purpose Input Output (GPIO) pins for external
system monitoring or control. Use settings on this tab to enable or disable pins and view or configure
pin settings.
4 Pin Power and I/O Connector
The S2000e power port includes voltage in, ground, and two digital I/O pins as shown.
Pin 3 – Ignition Sense or Digital I/O
Ignition Sense or Digital I/O Setting: Use the drop-down to select Enable Ignition Sense or Enable
Digital I/O.