User's Guide
Table Of Contents
- Contents
- 1 Introduction and Getting Started
- 2 Software Configuration
- 3 Advanced Settings
- 4 Product Specifications and Regulatory Information
- Product Specifications
- Regulatory Information
- Federal Communications Commission Notice (FCC – United States)
- Innovation, Science and Economic Development Notice (ISED – Canada)
- ISED Canada ICES-003 Compliance
- FCC and ISED RF Exposure Guidance Statement
- Cellular External Antenna Considerations:
- RF Radiation Exposure Guidance Statement
- Radio Frequency and Transmitted Output Power Information
- Product Certifications and Supplier’s Declarations of Conformity
- Wireless Communications
- Limited Warranty and Liability
- Safety Hazards
- 5 Glossary
5G INDUSTRIAL GATEWAY S2000e USER GUIDE 42
Diagnostics Tab
This tab displays detailed information used solely for troubleshooting or technical support.
Modem
Mobile Number (MDN): The phone number of your S2000e.
IMEI: The International Mobile Equipment Identity (IMEI) for your S2000e. This is a 15 digit code used
to uniquely identify an individual mobile station. The IMEI does not change when the SIM is changed.
IMSI: The International Mobile Subscriber Identity (IMSI) for your S2000e. This is a unique number,
usually fifteen digits, that identifies a Global System for Mobile Communications (GSM) subscriber.
FW Version: The version of the firmware (software) currently installed on your S2000e.
Network
Status: The status of the network.
Technology: Indicates the current cellular data connection, for example, 5G Sub6.
Network Operator: The name of the Mobile Network Operator (MNO).
Signal Strength (RSRP): The strength of the cellular signal, measured in dBm. Higher absolute values
indicate a stronger signal, for example: -80 dBm is a stronger signal than -90 dBm.
SINR: Signal to Interference plus Noise Ratio. An LTE-specific measure of signal quality, taking
interference and noise into account. SINR is a positive value, and higher numbers are better.
Band: The band in use for the current connection.
Roaming: Indicates whether roaming is on.
Cell ID: The ECGI code used to identify cells globally.