User's Guide
Table Of Contents
- Contents
- 1 Introduction and Getting Started
- 2 Software Configuration
- 3 Advanced Settings
- 4 Product Specifications and Regulatory Information
- Product Specifications
- Regulatory Information
- Federal Communications Commission Notice (FCC – United States)
- Innovation, Science and Economic Development Notice (ISED – Canada)
- ISED Canada ICES-003 Compliance
- FCC and ISED RF Exposure Guidance Statement
- Cellular External Antenna Considerations:
- RF Radiation Exposure Guidance Statement
- Radio Frequency and Transmitted Output Power Information
- Product Certifications and Supplier’s Declarations of Conformity
- Wireless Communications
- Limited Warranty and Liability
- Safety Hazards
- 5 Glossary
5G INDUSTRIAL GATEWAY S2000e USER GUIDE 48
Cellular Tab
In most configurations, the S2000e is used with a dynamic IP and SIM and the Access Point Name (APN)
is available from the network, for example: internet. However, if you are on a private network, you may
need to set the APN on this tab for the network to communicate with the S2000e.
Network Selection
Enable automatic network selection: When the ON/OFF slider is ON, your S2000e automatically
selects the best 5G available network and you cannot use the Select Network Manually button
below.
Select Network Manually: You may wish to use this option if multiple networks are available and you
have a preference. NOTE: This option is available only if Enable automatic network selection is off.
Click the button to scan for available networks, then choose the preferred network.
APN Settings
APN: Enter the APN for your private network.
CAUTION! Changing the APN may cause a loss of data connectivity.
Authentication: Select the authentication method for your private network from the drop-down
(PAP, CHAP, or None).
Username: Enter the user name for your private network.