User's Guide
Table Of Contents
- Contents
- 1 Introduction and Getting Started
- 2 Software Configuration
- 3 Advanced Settings
- 4 Product Specifications and Regulatory Information
- Product Specifications
- Regulatory Information
- Federal Communications Commission Notice (FCC – United States)
- Innovation, Science and Economic Development Notice (ISED – Canada)
- ISED Canada ICES-003 Compliance
- FCC and ISED RF Exposure Guidance Statement
- Cellular External Antenna Considerations:
- RF Radiation Exposure Guidance Statement
- Radio Frequency and Transmitted Output Power Information
- Product Certifications and Supplier’s Declarations of Conformity
- Wireless Communications
- Limited Warranty and Liability
- Safety Hazards
- 5 Glossary
5G INDUSTRIAL GATEWAY S2000e USER GUIDE 50
SIM Tab
On the Web UI Home page, the SIM Status panel shows SIM status information.
Carrier: The name of the Mobile Network Operator.
ICCID: The unique ID number assigned to the SIM card.
IMSI: The International Mobile Subscriber Identity (IMSI) for your S2000e. This is a unique
number, usually fifteen digits, that identifies a Global System for Mobile Communications (GSM)
subscriber.
MDN: The phone number of your S2000e.
APN: The access point name for your S2000e.
ECGI: E-UTRAN Cell Global Identifier. This is a 15-digit code used to identify cells globally.
RSRP: The strength of the cellular signal, measured in dBm. Higher absolute values indicate a
stronger signal, for example: -80 dBm is a stronger signal than -90 dBm.
RSRQ: Reference Signal Received Quality. A calculated value from RSRP and RSSI that provides a
measure of signal and interference.
SINR: Signal to Interference plus Noise Ratio. A measure of signal quality, taking interference
and noise into account. SINR is a positive value, and higher numbers are better.
PCI: The Physical Cell ID.